Stake Line routine with RTK

Rod W · Post by **Rod W** » Mon Dec 12, 2005 9:29 pm

I use the Stake Line routine with RTK to stake right-of-way boundaries. This would be easier if the offset info was shown beyond the end of the selected line segment so that I could stake the outside corner at a deflection. It would also make it possible to produce a line through a point. From the manual, I can see that the routine was written for Total Station surveys. With RTK the in/out field is replaced with N-S / E-W fields. This is the only info shown once you are beyond the end point of the selected line. Is there a way to get the offset info? If not, maybe the next release can solve this problem.

Thanks
RW

Post by **Jason Poitras** » Tue Dec 13, 2005 6:51 am

Hi Rod,

This is on our wish list and will be implemented in a future version, unfortunately it didn't make it into FieldGenius 2006. Next time ....