BS Point number in A T E

Discussion of FieldGenius related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
bobL
Posts: 29
Joined: Tue Dec 17, 2002 2:26 pm

BS Point number in A T E

Post by bobL » Mon Jun 13, 2005 8:29 am

When reveiwing our traverse in Active Traverse Editer, sometimes the
backsight slot is left blank? This makes it difficult to figure out where you were backsighting if you are reveiwing the job a month later or are backsighting in a different order other than consecutive points. I realize it probably has something to do with whether or not you record a distance to your backsight or not but, the BS number should be shown regardless.
If I enter the wrong BS pt # I want to know where I made the mistake. Has this been changed in FG 2005? ......thanks ... bob

Post Reply