cross sections

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
welshpe
Posts: 4
Joined: Thu Nov 09, 2006 6:40 am

cross sections

Post by welshpe » Mon May 07, 2007 10:48 am

When I apply a cross section template to a design surface and then plot the cross sections, they look good, but they appear to be at an incorrect elevation. i.e. the new surface is approximately 6"-12" too low in the cross section sheet. I also remember deleting surfaces in the past as well as deleting entire cross section sheets when updating. Any idea as to why the difference in elevation? Seems like maybe the template was applied at a different start than the cross section? May be off by a station.

Post Reply