Is it possible to select all unfrozen entities that have elevation (Z)=100.1?
(or Z=0)?
Have tried "select by properties", but can't seem to get there...
Alex.
Select by properties: elevation?
Moderators: Brian Sloman, Jason Poitras, James Johnston
2 posts
• Page 1 of 1
Select by properties: elevation?
by Alex Leonard » Sun Aug 19, 2007 9:50 am
- Alex Leonard
- Posts: 42
- Joined: Sat May 13, 2006 7:47 pm
- Location: Kona, Hawaii
by Glen Cameron » Sun Aug 19, 2007 5:33 pm
VIEW menu | LOOK FROM | RIGHT SIDE
Then use your window selection method, grabbing only what you want. What you see is the side view, so the higher on the screen, the higher it's elevation. Might take a bit of practice.
If you are looking for Points only, you can do it from inside the Active Coordinate Editor.
Then use your window selection method, grabbing only what you want. What you see is the side view, so the higher on the screen, the higher it's elevation. Might take a bit of practice.
If you are looking for Points only, you can do it from inside the Active Coordinate Editor.
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
City of North Bay, Ontario
- Glen Cameron
- Posts: 1395
- Joined: Fri Nov 08, 2002 12:18 pm
- Location: Corbeil, Ontario, Canada
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest