3D Polyline

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
Wes Mossing
Posts: 17
Joined: Sun Dec 08, 2002 3:39 pm
Location: Penticton, BC

3D Polyline

Post by Wes Mossing » Tue Aug 05, 2008 11:49 am

I cannot draw a 3D polyline? The commands "3P", "pl3p", "poly3p" or picking from the pulldown will not work. So I tryed just drawing the lines from node to node and then using the edit polyline command and that didn't work either. It brings up "An entity which is defined in the current UCS is needed." The "3P" command just shuts down the program.
I'm not sure about the UCS commands and not sure if that is my problem or not.
Any Idea?

Post Reply