isometric piping drawing

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

isometric piping drawing

Postby Survey Chad » Tue Dec 30, 2008 6:05 pm

Greetings,
I would like to be able to draw isometric piping drawings trhat I can get 3D data from.
I am a new user and have done an iso with MSCAD yet.
I want to be able to do things like: start at a pipe support, go a distance put in an oddball bend like 64 degrees, roll that bend up 10 degrees, go a distance and then be able to get a 3D distance back to the pipe support I started from.
Will MSCAD do that?
If not, is there an add-on program that would?
I am about to go on a remote job where internet access may not be available. Just wanted to find out before I go.
Thanks for any replies.
Chad
Survey Chad
 
Posts: 5
Joined: Tue Dec 02, 2008 8:14 am

Postby Jason Poitras » Wed Dec 31, 2008 3:40 pm

If you go to your Windows Start Menu | Programs | MicroSurvey | MicroSurvey CAD 2009, you will find a document titles "Using IntelliCAD". In this manual review the following sections:

Using three-dimensional coordinates
Drawing in three dimensions

Each topic has some example that you can use to practice with. This should get you started.
Jason Poitras
General Manager
[email protected]
User avatar
Jason Poitras
Site Admin
 
Posts: 443
Joined: Tue Oct 29, 2002 5:17 pm
Location: Kelowna, BC, Canada


Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest

cron