Reverse Line Label Bug

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
Matthew Fore
Posts: 35
Joined: Thu Feb 15, 2007 6:11 am
Location: USA - LOUISIANA

Reverse Line Label Bug

Post by Matthew Fore » Tue Mar 31, 2009 10:22 am

1) Sometimes I have to click twice on the line before the bearings will swap.

2) If you have previously changed the linetype scale, annotate, and finally reverse annotation the line scale will revert back to 1.

Happens in both Standard and Premium 2009.

glendon
Posts: 9
Joined: Wed Jan 27, 2010 10:55 am

Re: Reverse Line Label Bug

Post by glendon » Thu Jan 28, 2010 4:15 pm

Matthew Fore wrote:1) Sometimes I have to click twice on the line before the bearings will swap.
No problem on 2010, I just checked. probably because of the snap function, reverse annotation works after 'clear entity snaps'.
2) If you have previously changed the linetype scale, annotate, and finally reverse annotation the line scale will revert back to 1.
I always change the linetype scale by command "LTSCALE", which affects the whole drawing. if set the linetype scale for just a line, the default will be 1, that is what the "smart line" does, which will be redrawn after the reverse annotation .
Happens in both Standard and Premium 2009.

Post Reply