Smooth Contours

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Smooth Contours

Postby Peter G » Sat Jun 26, 2010 7:23 am

Hi,
Done this loads of times after labling up the contours, and even on the drawing I'm working on now did it and was fine. Then some how as well as seeing the smooth contours lines, next to them are the old straight ones.
Tried making new contours and then smoothing them. Still the same finish seeing both the smooth and the straight lines. Also same effect when working in inCAD.
Any ideas?

Peter
Peter G
 
Posts: 32
Joined: Wed Oct 07, 2009 7:48 am

Re: Smooth Contours

Postby Brian Sloman » Mon Jun 28, 2010 8:22 am

Hi, most likely the Spline Control Frame Lines have been turned on in this drawing - type SPLFRAME and make sure it is set to Off.
Brian Sloman
Development Manager
MicroSurvey Software Inc.
User avatar
Brian Sloman
Product Manager
 
Posts: 399
Joined: Fri Jan 07, 2005 4:42 pm
Location: Westbank, BC, Canada


Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 3 guests

cron