PLT file creation in MSCAD

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

PLT file creation in MSCAD

Postby chadd » Tue Nov 24, 2015 11:44 am

Good day.

I just wanted to seek information on how to create a PLT file of a CAD drawing. I am an Alberta Land Surveyor and part of the digital submission requires adding a plt file. I have installed an HP500PS +HPGL2 driver but the output is either garbled or has a very poor resolution not to mention having too big of a file. Most of the plt file that I see prepared runs only to about 250-250Kb for a typical 24x40 drawing.

There is an article on the helpdesk describing this but it was published almost ten years ago.

If anybody could point me to the right direction, I'd appreciate it.

Thanks.
chadd
 
Posts: 2
Joined: Sun Nov 22, 2015 6:20 pm

Re: PLT file creation in MSCAD

Postby chadd » Wed Nov 25, 2015 9:43 am

I guess you can close this thread. I have opted to use .tif files instead using pdf creator.
chadd
 
Posts: 2
Joined: Sun Nov 22, 2015 6:20 pm


Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest