Compute by tuned angle and distance

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Compute by tuned angle and distance

Postby T.M. Moretz » Thu Dec 04, 2003 10:54 am

Why can I not type or pick the point numbers for occupied point and backsight point? There is an option called "Points" but this clears all of the Osnaps but Endpoint and requires a line between the points, not much different than the option "Line". A workaround, after envoking the routine, is resetting the Osnaps to Insertion or Node each time but this seems awkward.
T.M. Moretz
Posts: 79
Joined: Fri Nov 08, 2002 1:31 pm
Location: North Carolina, USA

Turned Angle

Postby Glen Cameron » Thu Dec 04, 2003 1:30 pm

Hard to say why it is that way - just that the programmer wrote it that way.

When set to Point, it is looking for the END osnap and when set to Line, it i looking for the NEXT osnap.

I will send this on as a wish list item for change in the future.

Glen W. Cameron, C.E.T.
City of North Bay, Ontario
Glen Cameron
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada

Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 3 guests