Trimming etc.

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
GBS
Posts: 17
Joined: Fri Mar 21, 2003 9:31 pm

Trimming etc.

Post by GBS » Wed Dec 31, 2003 6:07 am

I use 2001 version and was noticing when using trim, if you miss the line you are going to trim the command ends and you have to repick everything you missed. Is 2002 different because other commands are similar to this and I know this does not happen in autocad.

just wonderin

ianw2
Posts: 139
Joined: Sun Nov 24, 2002 6:45 am
Location: Temecula, California
Contact:

Post by ianw2 » Wed Dec 31, 2003 9:02 am

In 2002, the command does not end. I remember the situation of which you speak, and, yes, it was frustrating if you miss-snapped.

In 2002, if you miss your trim edge, it slips to a crossing window trap. If there are no lines in the trap, it reverts back to asking you to select a line.

If you miss a line to be trimmed, it just keeps on wait ing for your aim to get better until you hit <ENTER> to end the command.
Ian Wilson
Ian Wilson Land Surveying, Inc.
Temecula CA 92591
(951) 684-1044

Post Reply