Scale Factor on Right_of_Way command?

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Scale Factor on Right_of_Way command?

Postby gkhickman » Wed Mar 09, 2005 12:31 pm

Is there a way to set it up so it will take into account the scale factor when i'm doing offsets and using the right_of_way command? or do i just have to figure it out manually?
gkhickman
 
Posts: 6
Joined: Wed Mar 09, 2005 12:29 pm
Location: Fort St John

scale factors

Postby Glen Cameron » Thu Mar 10, 2005 5:29 am

The Right-of-way command does not use any scale factors. You manually enter in the correct distance to offset the original linework by. The Offset command is a 2D CAD command and will not use the scale factor either.

Cheers,
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
Glen Cameron
 
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada


Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest

cron