I need to mark the road in my drawing at every 50' interval (so if my road is 150', I would need to make 3 tick marks along the length of the road). I have a centerline for my road, and using cogo I can calculate where to put my tick marks. Is there a simpler way in MSCAD 2004?
Thank you in advance for any assistance.
Tick Marks at 50' intervals
Moderators: Brian Sloman, Jason Poitras, James Johnston
-
Glen Cameron
- Posts: 1395
- Joined: Fri Nov 08, 2002 12:18 pm
- Location: Corbeil, Ontario, Canada
- Contact:
Measure command
You could try the MEASURE command as it will place a cad point at the interval specified. Then set your point definition to be a tick (or whatever you wish). Keep in mind that all points will now look like the tick.
You could also have the measure command place your own Block instead of a point, at the specified locations, this way the rest of the points could remain as dots.
Cheers,
You could also have the measure command place your own Block instead of a point, at the specified locations, this way the rest of the points could remain as dots.
Cheers,
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
City of North Bay, Ontario