Error creating text. Resbuf 3432

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Error creating text. Resbuf 3432

Postby zubler » Thu Aug 11, 2005 12:16 pm

I have just re-installed MicroSurvey 2005 on a freshly reformatted hard drive. I am now gettting the following error when I inverse between 2 points. "Error creating text. Resbuf 3432".

What is the problem?

Kirby
zubler
 
Posts: 17
Joined: Thu Nov 14, 2002 11:22 am
Location: Edmonton Alberta

text error

Postby Glen Cameron » Thu Aug 11, 2005 4:41 pm

I would check your labeling defaults under the MsAnnotate menu. It sounds like one of the entries for bearing or distance labeling, is not set correctly.

If you wish, you could reset the labeling defaults to factory settings by going under the MsTools menu -> MicroSurvey System Defaults -> Reset to FactoryDefaults - then go back to the same menu and pick Save As Default Configuration.

Then the routine should work correctly for you.

Cheers,
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
Glen Cameron
 
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada

Postby zubler » Fri Aug 12, 2005 5:30 am

Thanks Glen. It's working fine now.


Kirby
zubler
 
Posts: 17
Joined: Thu Nov 14, 2002 11:22 am
Location: Edmonton Alberta


Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest

cron