Changing Area Units

Discussion of MicroSurvey inCAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Changing Area Units

Postby Mark D » Wed Jan 04, 2012 12:46 pm

I was just trying to get my areas set up. Currently when I label an area it displays in sq. ft. and acres. I would like to change the setting to display sq. ft. and sq. m. but I have been unable to figure this out (other than changing the label defaults which is fairly straight forward).

Mark D
Posts: 1
Joined: Wed Jan 04, 2012 11:09 am

Return to MicroSurvey inCAD

Who is online

Users browsing this forum: No registered users and 1 guest