nothing on screen

Discussion of MicroSurvey inCAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

nothing on screen

Postby D.W. Converse » Thu Aug 07, 2003 7:51 am

I just read a note about the Service patch no 4, stating that Service Patch no 2 needs to be installed befor Service Patch no 4 is installed.
I cannot remember if I did this or not, my problem is nothing shows up on the screen. The points are in the data base, because I can inverse and get a line. The line will disappear when I refresh the screen.
Any ideas?

Should I uninstall everything and install SP2 and then SP4?
D.W. Converse
 

Blank Screen

Postby Glen Cameron » Sat Aug 09, 2003 6:02 pm

I would check to ensure that your system toggles are set to draw the point data, etc. (Microsurvey menu -> MicroSurvey Defaults -> System Toggles) If they were off then turn them all on - then go under the MicroSurvey menu -> Database Utilities -> Update Drawing From Database, and see if they appear now.

Cheers,
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
Glen Cameron
 
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada


Return to MicroSurvey inCAD

Who is online

Users browsing this forum: No registered users and 1 guest

cron