Proportion on Arc

Discussion of MicroSurvey inCAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Proportion on Arc

Postby Guest » Wed Aug 18, 2004 8:42 am

when I proportion an arc with the draw lines/curves set on my toggles I get an error drawing arc and no new points are created. If I turn off the draw lines/curves in my hot toggles the arc proportion command works.

ACAD2002 Incad 2004

Curve Proportion

Postby Cary Glazier » Wed Aug 18, 2004 8:55 am

I think the problem is the object snaps need to be set to none and the command is not doing it...I cleared my osnaps and it worked.
Cary Glazier

Return to MicroSurvey inCAD

Who is online

Users browsing this forum: No registered users and 1 guest