Discussion of FieldGenius related issues and questions.
2 posts • Page 1 of 1
I have noticed on my iPaq 2215 running FG 2004 1.0.7 that I must set the prism offset to -30 mm to match the instrument (Topcon, non-robotic). After looking at the manual I was under the impression that the distances would be incorrect by doing this, but after some simple checking with my steel tape I see that leaving the offsets at zero in the iPaq resulted in that rough tenth difference. When I set them the same in my iPaq and instrument the distances check. Please look into this and advise. I also notice the same issues from my "iPaq specific" post below still exist in this latest version, but I do realize my post was made only a week or two before this latest release. Thanks for the continuing improvement.
- Jason Poitras
- Site Admin
- Posts: 443
- Joined: Tue Oct 29, 2002 5:17 pm
- Location: Kelowna, BC, Canada