lot reports

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

lot reports

Postby white-avalanche2004 » Mon Sep 20, 2004 7:02 am

I must have something turned-off. I pick objects in a drawing to create a lot front, left, back, right, I finish, but the report only shows area-not bearing, distance, coordinate and area. What should I do next?
white-avalanche2004
 

Lot Report

Postby Glen Cameron » Mon Sep 20, 2004 8:06 am

If this is the type of report you are looking for, then the way I generated this was:
1) Have all lines drawn on screen.
2) MsTools menu -> Subdivision Design -> Create Edit Lots and Blocks.
3) Create/Edit Lots
4) Create/Edit Lots Pick Sides
5) Enter the Lot Number and Start Selecting Objects
6) Pick on Front then pick the lines for the front of the lot – do the same for Left, Rear and Right. Pick Finish when done.
7) The report should be created automatically, example below. (Spacing is off a bit due to the font, etc.)

C:\SAMPLES\4PNT Job Description:
10:55:16 09/20/04 Page No.: 1
----------------------------------------------------------------------------
Lot : 1

From PNT Bearing Distance Northing Easting To Pnt
99 S55°56'22"W 43.17 37.716 179.176 85
ARC= 45.89 RAD= 38.11 DELTA= 69.0007 - Area RadNum=100
85 N12°58'25"W 119.69 13.538 143.413 3
3 N83°19'07"E 64.45 130.174 116.542 87
87 S35°07'29"E 60.28 137.673 180.558 86
86 S35°26'50"W 62.18 88.372 215.239 99
Square Feet : 7175.6 Acres : 0.165
Square Metres: 666.63 Hectares : 0.067
TOTAL Traverse Distance : 349.77
TOTAL Traverse Perimeter: 352.50
TOTAL Traverse Stations : 5
ERROR of Closure : 1:INFINITY
Frontage: 45.892565.

Cheers,
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
Glen Cameron
 
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada


Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest

cron