Has anyone devised a way to annotate offests from points to lines in a global way. I have as constructed drawings for a subdivision(s) that requires locations and offsets to each side boundary on a plan of the services (stormwater, sewer and water) to each lot.
Its easy to do manually but rather tedious when there are a couple of hundred points to pick. I envisaged a routine that after all the points were selected then MSCAD raced off and searched all lines within say 3 metres of the point and wrote the offsets on the drawing. Sounds very simple thing to do!!
Discussion of MicroSurvey CAD related issues and questions.
1 post • Page 1 of 1