When reveiwing our traverse in Active Traverse Editer, sometimes the
backsight slot is left blank? This makes it difficult to figure out where you were backsighting if you are reveiwing the job a month later or are backsighting in a different order other than consecutive points. I realize it probably has something to do with whether or not you record a distance to your backsight or not but, the BS number should be shown regardless.
If I enter the wrong BS pt # I want to know where I made the mistake. Has this been changed in FG 2005? ......thanks ... bob
Discussion of FieldGenius related issues and questions.
1 post • Page 1 of 1