I use the Stake Line routine with RTK to stake right-of-way boundaries. This would be easier if the offset info was shown beyond the end of the selected line segment so that I could stake the outside corner at a deflection. It would also make it possible to produce a line through a point. From the manual, I can see that the routine was written for Total Station surveys. With RTK the in/out field is replaced with N-S / E-W fields. This is the only info shown once you are beyond the end point of the selected line. Is there a way to get the offset info? If not, maybe the next release can solve this problem.
Discussion of FieldGenius related issues and questions.
2 posts • Page 1 of 1
- Jason Poitras
- Site Admin
- Posts: 443
- Joined: Tue Oct 29, 2002 5:17 pm
- Location: Kelowna, BC, Canada