description Translation library

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
John Gallagher
Posts: 64
Joined: Fri Nov 08, 2002 1:35 pm
Location: Long Island New York

description Translation library

Post by John Gallagher » Wed Nov 20, 2002 8:32 am

I just set up a description translation library on one computer in the office and would like to copy it to another computer.I took a look in the MSCAD2002 folder hoping to see a file just modified that on opening would be the library,and I could then just copy it over to the second machine.
So far I haven't seen or opened anything that fits the bill.Is it possible to just copy the library from one computr to another or will it have to be manually entered on each?
Thanks for any help,
John Gallagher
John Gallagher

Mark Budgen

Post by Mark Budgen » Wed Nov 20, 2002 8:49 am

Hi John,

Look for the following files on the computer with the correct Description Translation Library:

IC_CCPD.DEF
IC_CCPD.MP
IC_CCPD.NX
IC_CCPD.ST

These are found in the \mscad2002\mscad directory. Please copy all of these files (4 in total) to the other computer and place tham in the same folder (overwrite the existing files). This will copy the DTL to the other computer. I hope this helps.

John Gallagher
Posts: 64
Joined: Fri Nov 08, 2002 1:35 pm
Location: Long Island New York

description Translation library

Post by John Gallagher » Wed Nov 20, 2002 9:02 am

Thank's Mark.That did the trick.
John Gallagher
John Gallagher

Post Reply