lost points

welshpe · Post by **welshpe** » Wed Apr 18, 2007 6:12 am

my points disappeared? I tried rescaling the drawing and changing the points. Nothing works? The point numbers, descriptions, and elevations show up but no points. mscadd 2005 1.3. premium

rwhatman · Post by **rwhatman** » Wed Apr 18, 2007 8:40 am

welshpe wrote:my points disappeared? I tried rescaling the drawing and changing the points. Nothing works? The point numbers, descriptions, and elevations show up but no points. mscadd 2005 1.3. premium

Toggle Perference
Cad drawing Controls

Turn On - Draw Points (Nodes)

Hope this is what you want.

Glen A. Quarmby · Post by **Glen A. Quarmby** » Wed Apr 25, 2007 3:02 pm

That same thing happened to me today. Toggle settings are set to draw nodes but they aren't there. The usual commands to fix this including Rescale, Update Points or ReCalc Traverse don't help.
I started a fresh drawing and read the points in to fix it.
This was an AutoCad drawing someone sent me and they don't always behave like they should.

Richard Sands · Post by **Richard Sands** » Wed Apr 25, 2007 9:33 pm

I've had times when jobs appear to not show the points. I've found a save, close, exit Mscad, restart Mscad, open job, save again and it fixes the problem.
not sure if its the same as described here?
regards, Richard

MicroSurvey Software Inc.

lost points

lost points

Re: lost points

Point Node

lost points