Measure Command
Moderators: Brian Sloman, Jason Poitras, James Johnston
-
Wes Mossing
- Posts: 17
- Joined: Sun Dec 08, 2002 3:39 pm
- Location: Penticton, BC
Measure Command
I can't seem to get the measure command to work. Years ago I used this command to put little blocks on a line or polyline to make a good looking fence but now I can't seem to make it work. Am I missing something?
-
Glen Cameron
- Posts: 1395
- Joined: Fri Nov 08, 2002 12:18 pm
- Location: Corbeil, Ontario, Canada
- Contact:
Divide and Measure
What verion and service patch of MSCAD are you using?
MSCAD2002 SP#3, available from this web-site, had a problem with thoise commands so we provided a fix. If you have installed SP#3, be sure to grab the fix, from the same location (support page, MSCAD2002).
If you are running an older Service Patch, then I would suggest upgrading to SP#3 and grabbing the additional patch.
Cheers,
MSCAD2002 SP#3, available from this web-site, had a problem with thoise commands so we provided a fix. If you have installed SP#3, be sure to grab the fix, from the same location (support page, MSCAD2002).
If you are running an older Service Patch, then I would suggest upgrading to SP#3 and grabbing the additional patch.
Cheers,
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
City of North Bay, Ontario
-
Wes Mossing
- Posts: 17
- Joined: Sun Dec 08, 2002 3:39 pm
- Location: Penticton, BC
Measure
I am running SP 4, but I did have to reload everything just yesterday. I had some other computer problems and uninstalled MS Cad, reloaded the SP 2 off of disk, loaded SP 3 then 4 off the website.