Does anyone have any clue why when I'm doing cogo calculations, some times no line or distance will be created between points? I will be calculating a string of points and one or two random calculations will not create any graphics. I do not leave the command or zoom or pan. Sometimes if I overwrite one of these odd points, weird vectors will be created joining the new location to other points that shouldn't be connected.
I also notice that sometimes my pan button will zoom instead. Usually if I leave the program and come back, that will be fixed.
I'm still getting a crash problem where a message comes up that says a resource was expected and then Microsurvey shuts down. This generally happens if I've been doing a lot of cogo. If I remember to close the program, I can sometimes head it off. Sometimes I get a hint that something is going to happen--all my buttons will go white. When that happens I save and exit and my work is usually intact. Still, it's time-consuming to have to recover my plan from Autosave and restore the database.
I have all the SPs installed.
Any ideas? Thanks in advance.
No lines or distances created by cogo
Moderators: Brian Sloman, Jason Poitras, James Johnston
5 posts
• Page 1 of 1
No lines or distances created by cogo
by Carole » Thu Jul 26, 2007 8:48 am
- Carole
- Posts: 33
- Joined: Mon Jul 25, 2005 8:33 am
by Darcy Detlor » Tue Jul 31, 2007 12:45 pm
What operating system are you running and with what Microsoft service packs?
-
Darcy Detlor - Site Admin
- Posts: 205
- Joined: Tue Oct 29, 2002 10:14 am
- Location: West Kelowna, BC
COGO LINES
by Richard Sands » Tue Aug 07, 2007 1:47 pm
I have this trouble also. My new PC running WinXP Pro gave this problem yesterday. Couldn't get it to work at all. MSCAD2005 SP1.3 downloaded off the web last week.
I have had this problem surface in past. Again with XP Home and Pro.
regards, Richard
I have had this problem surface in past. Again with XP Home and Pro.
regards, Richard
- Richard Sands
- Posts: 425
- Joined: Mon Feb 14, 2005 1:10 pm
- Location: Tasmania
No lines in COGO
by Richard Sands » Wed Aug 22, 2007 12:24 pm
This surfaced again yesterday. using Batch COGO the problem occured when I re-ran BC this time with a bearing addition and a scale factor applied. I found it ran OK but there was a missing line in the middle.
It also wouldn't connect the lines using COGO with bearings/ distance and line turned on in hot toggles.
It's not just in Batch Cogo that this happens though.
regards, Richard
It also wouldn't connect the lines using COGO with bearings/ distance and line turned on in hot toggles.
It's not just in Batch Cogo that this happens though.
regards, Richard
- Richard Sands
- Posts: 425
- Joined: Mon Feb 14, 2005 1:10 pm
- Location: Tasmania
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests