Select by properties: elevation?

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Select by properties: elevation?

Postby Alex Leonard » Sun Aug 19, 2007 9:50 am

Is it possible to select all unfrozen entities that have elevation (Z)=100.1?
(or Z=0)?

Have tried "select by properties", but can't seem to get there...

Alex Leonard
Posts: 42
Joined: Sat May 13, 2006 7:47 pm
Location: Kona, Hawaii

Postby Glen Cameron » Sun Aug 19, 2007 5:33 pm

Then use your window selection method, grabbing only what you want. What you see is the side view, so the higher on the screen, the higher it's elevation. Might take a bit of practice.

If you are looking for Points only, you can do it from inside the Active Coordinate Editor.
Glen W. Cameron, C.E.T.
City of North Bay, Ontario
Glen Cameron
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada

Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest