For some reason now when I do COGO the default first "Enter From Point" is 2 rather than 1.
There is no point 1 in my template. So that's not the reason 2 is offered as the first point.
Hot Toggles says "Next pt: 1". So the Next pt. is set correctly.
What have I failed to re-set or clear out so that the initial From Point offered is 1 instead of 2?
COGO - First Point default
Moderators: Brian Sloman, Jason Poitras, James Johnston
-
B. K. Lemons
- Posts: 96
- Joined: Sun Nov 06, 2005 10:13 am
- Location: Nacogdoches, Texas
- Contact:
-
Richard Sands
- Posts: 425
- Joined: Mon Feb 14, 2005 1:10 pm
- Location: Tasmania
COGO FIRST POINT
Check what your default drawing Hot Toggles is set to (not sure why HT says 1 in new dwg) - I imagine it carries that setting forward. You may need to reopen your template. reset Hot Toggles save as dwt, close and try again.
There may just be a glitch in system?
regards, Richard
There may just be a glitch in system?
regards, Richard
-
B. K. Lemons
- Posts: 96
- Joined: Sun Nov 06, 2005 10:13 am
- Location: Nacogdoches, Texas
- Contact:
That's what I thought, something in the template that needs to be reset, or the template needs to be recreated from scratch. Got too late before I could try that.
Fortunately, this isn't a bottleneck that stops work. Just enter 1 for first point. After that, it properly suggests 2 for second point. It's just one of those things that one would like to clear up in the beginning so that he doesn't have to look at it every time.
It will probably get resolved by accident the same way it was created by accident.
Fortunately, this isn't a bottleneck that stops work. Just enter 1 for first point. After that, it properly suggests 2 for second point. It's just one of those things that one would like to clear up in the beginning so that he doesn't have to look at it every time.
It will probably get resolved by accident the same way it was created by accident.