Is there any way to extract a range of point numbers to create a surface? When creating contours I only want to use points with actual ground elevations not steps or floor elevations. I see where you can select them by elevation range and manual selection.
Thanks
Using points for surface
Moderators: Brian Sloman, Jason Poitras, James Johnston
-
Richard Sands
- Posts: 425
- Joined: Mon Feb 14, 2005 1:10 pm
- Location: Tasmania
EXCLUDE POINTS FROM DTM
see this post, may be helpful.
http://www.microsurvey.com/forums/viewt ... ht=surface
Graphic editor is a useful tool for this. You can select a grouping of points and then create a surface from them.
You can also just select all points and then deselect the ones of your chosing, but remember to deselect any points before you run any breaklines as they (breaklines) get removed in the removing points from surface routine.
http://www.microsurvey.com/forums/viewt ... ht=surface
Graphic editor is a useful tool for this. You can select a grouping of points and then create a surface from them.
You can also just select all points and then deselect the ones of your chosing, but remember to deselect any points before you run any breaklines as they (breaklines) get removed in the removing points from surface routine.