New setup problems with Liscence.

Allsite · Post by **Allsite** » Wed Sep 03, 2008 12:51 am

I originally installed my 2008 upgrade on an older Laptop. The new Laptop was getting repaired.
I had previously installed the trial version of 2008 on my new laptop which had expired.
I tried to reinstall the new software over the trial software when I got my new laptop back from the repairers, had a few problems, It didn't seem to install properly but after i installed the USB Key, it worked.
I did however notice that I had no help available. It apears as if it has not been installed.
Today I tried to contour a job & the basic functions apear to be missing.
I have tried to install it about 3 times now but have had no improvment.

What are the correct steps to getting the software to run on an additional PC, What can i do to fix it.
Regards Jeff

Glen Cameron · Post by **Glen Cameron** » Wed Sep 03, 2008 5:57 am

Please see my responce to your helpdesk ticket.