Question 2005 "CAD Line Computations" window.

[B. K. Lemons]

Haven't used the software in a while so am a bit rusty.

Until earlier today, I could click on a individual cogo line and delete it individually. Or I could click on a distance or bearing, and that would bring up a window to and change the font, etc.

But now, suddenly, when I click on an individual line, up pops a "CAD Line Computations" window. And when I click on a distance or bearing, a little window comes up to change the text, but that is all.

What did I turn on or off that should be turned off or on to put it back the way it was?

Thanks if anyone knows.

[B. K. Lemons]

MS Tools > MicroSurvey System Toggles ... > Dialogs tab > turn on Use Single Point Editor.