XYZ Coding

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

XYZ Coding

Postby keramat » Wed May 16, 2012 4:48 am

How to coding this sample by xyz method ?
xyz.JPG (21.72 KiB) Viewed 1053 times
Posts: 1
Joined: Tue May 15, 2012 12:57 am

Re: XYZ Coding

Postby getrsurveyed » Wed May 16, 2012 8:32 am

XYZ coding is for locating objects in the field.. your map looks like a subdivision with lot lines so I'm not sure how relevant XYZ coding would be .. however if you had a code for Lot Corner as "LC" then your coding would proceed around one five sided lot as follows..


Z is for straight lines so the above coding would locate the first three corners and the Y code would locate a line radiating from the third corner, then the next two Z codes would locate the next two lot corners and the dot code " . " would close the lot on the first code
I think I have that correct...
Posts: 49
Joined: Fri Nov 04, 2005 1:59 pm
Location: Cambridge Oh

Return to MicroSurvey CAD

Who is online

Users browsing this forum: No registered users and 1 guest