problem with Target Manager for ver 6.0.6.6

Discussion of FieldGenius related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

problem with Target Manager for ver 6.0.6.6

Postby Cheng » Mon Nov 11, 2013 3:37 pm

Hi Jason,
I found a bug for FG2012 (6.0.6.6 and newer). When choosing FS or BS prism type from Leica Prism list in Target Manager, after taking a shot, the prism constant in Leica Total Station will be unexpectly changed. When I did test, I pre-set prism constant inside the Leica TS as 0.0mm, then Leica 360 Prism type was selected in FG, after shooting, the prism constant inside the TS was changed from 0.0mm to 3000mm. Choosing different Leica Prism type could lead this change up to 7000mm.

cheng
Cheng
 
Posts: 10
Joined: Sat Apr 30, 2005 4:54 am

Re: problem with Target Manager for ver 6.0.6.6

Postby John Coldrick » Wed Nov 20, 2013 9:09 am

Hello Cheng,

Thank you for the post.

What total station are you using and what is the Leica firmware of the total station?

We have a Leica TS15 here and within the Leica Viva firmware (ver 4.60), it is impossible to edit a Leica prism and offset. What steps did you follow to be able to edit a Leica default prism? We designed the Target Manager around the fact that these can not be altered.
Thank you for the feedback,

John Coldrick
MicroSurvey Software Inc.
John Coldrick
 
Posts: 6
Joined: Wed Jan 04, 2012 9:03 am
Location: West Kelowna, BC

Re: problem with Target Manager for ver 6.0.6.6

Postby Cheng » Wed Nov 20, 2013 6:11 pm

Hi John,

The TS I tested is old, TCA1800.
Cheng
 
Posts: 10
Joined: Sat Apr 30, 2005 4:54 am

Re: problem with Target Manager for ver 6.0.6.6

Postby John Coldrick » Thu Nov 28, 2013 7:12 am

Hello Cheng,

Yes, that is an older instrument. I suspect you are using the GSI driver for that one. Since that is such an old instrument, very little Target Manager testing was done using it. We may need to put a warning on our website that the Target Manager may not be fully supported using those older instruments.

Thank you very much, again, for the feedback.
Thank you for the feedback,

John Coldrick
MicroSurvey Software Inc.
John Coldrick
 
Posts: 6
Joined: Wed Jan 04, 2012 9:03 am
Location: West Kelowna, BC


Return to FieldGenius

Who is online

Users browsing this forum: No registered users and 0 guests

cron